how to see signal strength on devices and enter service mode?

[smith007]

Hello Molino,

You enter the Servicemode on the BT by the code.

*0 <code>.

Dependent on the code you select automatically the Service or Mastermode.
Have a look on the display of the BT when you enter the code.
You will then see the Mode.

In Olink you must choose Servicemode.
Klick the button "devices".
Select a registered Device right click and choose properties.
You will then see in the section "RF Signal Level" the signal strength of the device.
Dont worry if you see 0%.
The strength will be logged only when you in Service mode and the device was triggert.
To see the actually signal strength trigger the device and you will see immediately the value.

Regards Christian